Paul, Miles, Jim Hiltz, Jim MacLean
we discussed several interesting things tonight:
Leo showed how to make a sanding disk from 3M pads embedded with carborundum powder using an epoxy that bonds leaving a flexible finish instead of a hard finish. (E 6000)
He discusses further the design of the new vase project.
Jim Hiltz had a good start made on his.
Leo went through the lathe setup for mounting the vase to profile it and then how to make a plywood base template to guide the router cut that will make the inlay.
Leo showed us a variety of hefty jogs he made to enable hollowing out a vase .
No comments:
Post a Comment