Large Router Plane drawing. A-A is if you cut the drawing “A” in half and turn it on end.
Use two pieces of wood..a hard wood for the sole such as service berry, white oak, hornbeam and another wood for the rest of the body eg maple, walnut etc
Glue up the pieces
Do the above drawing on graph paper carefully and Lay this out on the wood.
Drill the holes..make sure of what size cutter will be used.
Saw out the slot
Router the top profile
Sand up
Small router plane 4 1/4 inch x 2 3/4 inches 7/8 inch diameter hole.The depth is 1 1/2 inches
Use a hard wood for the sole to resist wear : Hornbeam, Serviceberry, Ironwood,
Below photos are a Steady Rest
Steady Rest Jig (Jim Hiltz)
3/4/ threaded rods, bolts, square bar, wheels ( from a skate board)
Hardwood
Use a hard wood for the sole to resist wear : Hornbeam, Serviceberry, Ironwood,
Below photos are a Steady Rest
Steady Rest Jig (Jim Hiltz)3/4/ threaded rods, bolts, square bar, wheels ( from a skate board)
Hardwood
 |
|
|
No comments:
Post a Comment