February 17, 2026

Miles,Paul,Rick,Francis,Jim MacLean,   Lawrence

Miles's Scroll saw project

Rick-Spruce Dish

Rick Spruce,-Birch

The meeting today was excellent.

Lawrence demonstrated a charcoal pouch he made to use with the perforations carving template he showed us at last session. He used a lump of charcoal from the fire place and pulverized it and wrapped it in  cloth. One dabs it on the paper template and when the paper is removed one connects up the dots which are left on the workpiece.

Lawrence discussed the salient issues with respect to spraying finishes:

1    Use a good spray gun, one that has a regulator to enable changing the spray field.
2    Make sure ventilation is good so that the air is evacuated as needed
3    Use a good face mask to trap fumes: one with filters that are replaceable is best
4    Spray beyond the workpiece and with the grain pattern
5    Before spraying, sand the workpiece with 120, 150 paper. Using finer grits is usually not needed
6    Let the piece dry-20-30 minutes before proceeding to a new coat
7    Lay down lots of coats
6    After each coat, cut the last layer with finer sand paper and Varsol lubricant
Rick brought several of his burls and discussed how he goes about turning them...paying strict attention to grain patterns and preserving intricate patterns and knots etc

Francis discussed the issue of radon gas in a home. He has been getting high readings and has had to get a ventilation system installed.  The Passerini Company is local and will do a 90 day radon detection analysis at a cost of $500.(Paul's information)

He also had questions about the use of several chucks-The McNaughton coring system and the Barracuda type chucks. Lawrence was able to explain  how to use the systems.

Lots of discussions about the late  Leo Macneil's expertise and teaching skills and some of the past (deceased) members woodwork skills.

Lawrence demonstrated several pin chucks made of wood and jam chucks.He also demonstrated several turning tools which he made from Vehicle struts!

Lawrence took Paul's bowl out of the refrigerator kiln. The humidity was down to 10-15 % in various spots. He had coated the bowl inside and out with white glue diluted with water to prevent too rapidly  drying the wood.

Rick suggested he bring in an old school desk and use it to go through a finishing session.

Above:  Paul's  improvised Polishing system